958-000324-002, March 2005)

SANworks Management appliance or other server running the HP Proactive Services

software.

NOTE:

To order Proactive Services software, contact your HP customer service representative.

Configuring call home via LAN on the HAFM appliance

Use these steps to configure call home on the HAFM appliance.

1. Verify that the H A F M appliance is connected to a LAN with access to the

server running the H P Proactive Services software.

2. Locate the hp-lan.properties file in the following location:

<install_home>\CallHome\Config

Following is an example of file contents:

CSGIpAddress=localhost

3. Using any ASCII text editor, ma ke the following changes to the hp-lan.properties

file:

a. CSGIpAddress — Delete localhost and enter the IP address of the HP

Services Gateway in appropriate format (xxx.xxx.xxx.xxx).

4. If you have changed the contents of the hp.lan.properties file, reboot the

HAFM appliance.

Enabling call home via LAN

The HAFM appliance is now configured to automatically call home through the L A N

connection to a service support facility to report Director, Edge Switch, or HAFM

appliance problems.

You must now enable the call hom e feature on the H AFM appliance itself as well as

each Director a n d Edge Switch through the HAFM application on the HAFM appliance.

To enable the call home feature on the HAFM appliance:

1. Log in to HAFM (see Logging into HAFM. The HAFM main window is

displayed (Figure 56).

2. Click Monitor > Event N otiﬁcation > Call H ome....TheCallHome

Event N otification Setup dialog box is displayed (Figure 57).

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00