958-000324-002, March 2005)

3. Place a check mark in the EnableCallHomeEventNotiﬁcation option.

This enables the ca ll home function for the HAFM appliance, as well as for

all Directors and Edge Switches that have also been enabled for call home

notification.

To enable the call home feature on individual Directors and Edge Switches, perform the

followingforeachDirectorandEdgeSwitch:

1. From the HA F M m ain window, open the Element M anag er for the device. The

Hardware View for the device is displayed.

2. Click Maintenance>EnableCallHomeNotiﬁcation.

3. PlaceacheckmarkintheEnableCallHomeEventNotiﬁcation option.

4. See Testing remote notification for instructions on testing the call home feature.

Testing remote notification

If call home notification features are enabled, set up the HAFM application to test

theseremotenotificationfeatures. BecausethefeaturesareconfiguredattheHAFM

application, call home event notification is enabled for multiple Directors and Edge

Switches.

NOTE:

Prior to testing remote notification, complete the steps in the previous sections:

• Configure the call home via Dial-Out Feature

• Configure Proactive Services Call Home via LAN Feature

To test remote notification:

1. Enable call home event notification through the HAFM appliance.

a. Click Monitor > Event Notiﬁcation > Call Home....TheCallHome

Event Notification Setup dialog box is displayed (Figure 57).

• If a check mark is displayed in the check box, call home is enabled.

• Ifacheckmarkdoesnotdisplayinthecheckbox,clicktheboxto

addacheckmark.

2. Click Send Test. A call home test message is transmitted and an Information

dialog b ox is displayed.

3. Click OK.

Configuration