HP StorageWorks HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Release Notes (AA-RV1YA-TE, March 2005)

Hardware and Software Support
35HSG80 Enterprise Modular Storage RAID Array Fibre Channel Solution Software V8.8 for
Windows NT, Windows 2000, and Windows Server 2003 (32-bit) Release Notes
Multiple Agents
This Solution Software Kit contains an SWCC Agent that supports controller
locking during CLI command execution, which allows support for multiple
Agents. This locking feature is required in order to use the Management
Appliance in addition to the host-based SWCC Agent. However, it is not
recommended or required to use multiple Agents for any other purpose.
Note: SWCC Agent V2.3.2, Build 79 or later supports the locking feature. This release
of Solution Software exceeds this requirement.
Multiple Management Sessions
Though multiple Clients can be used to monitor the storage system, HP
recommends that only one instance of storage system management be active at a
time. The Client allows for multiple management sessions, but there are no
ownership rights given to any particular session. Without a highly coordinated
effort, multiple management sessions can undermine the integrity of system
maintenance. This same principle applies to multiple management sessions
initiated through the Management Appliance as well.
SWCC Client Installation
The SWCC client software is installed on your host system from the HP
StorageWorks Solution Software CD-ROM.
1. Insert the Solution Software CD-ROM into the host system, or start the
installation by browsing to Launch.exe. A menu appears on your screen.
The installation program provides one primary option: Solution Software for
Windows.
2. Click the Driver Install button.
3. Select SWCC to install.
4. Select HSG80 Controller for ACS85 or newer and complete the installation
as prompted.