HP Comware 5 Debug Manual Vol 1

Field
Description
DOT1X UnauthorTrans Receive an Error
msg(ErrCode)...
802.1X received a message that should not be received in
unauthorized state.
Bad msg. The message had invalid parameters.
SlaveBoard/IO: DOT1X Config By Port
failed
802.1X failed to configure ports on the standby MPU or interface
cards.
MAIN/Slave: RPC get DOT1X Config By
Port res: failed
The active MPU or the standby MPU failed to obtain the
port-specific 802.1X configuration from interface cards.
MasterBoard: DOT1X Config By Port
failed
The active MPU failed to obtain the port-specific 802.1X
configuration on interface cards.
Failed to get this port name string
because it doesn't exist or isn't up.
802.1X failed to get a port name because the port did not exist or
was down.
DOT1X set LogicState failed 802.1X failed to set the control state of the logical port.
DOT1XSOP unAsgn GuestVlan from port
failed
DOT1XSOP failed to cancel a guest VLAN assignment.
Warning:DOT1X Que is almost full, CUT
user msg is dropped.
CUT user messages were dropped because the 802.1X queue was
getting full.
Failed to del 1X drv-MAC in DOT1X
Backup Deal.
802.1X failed to delete the drive MAC address during backup.
Fail to get port MAC Max LearnStatus on
port :PortIndex ,Errcode is :ErrCode
802.1X failed to get the maximum number of MAC addresses
allowed on the specified port.
Failed to move MBUF to buffer. The device failed to move BPDUs to contiguous blocks of memory.
Failed to cut ethernet head The device failed to ignore the Ethernet header of packets.
Failed to process MGV for the same MGV
entry.
802.1X failed to process MGV because the same MGV entry
already exists.
Failed to unauthorize port-based
LogicState.
802.1X failed to unauthorize the port-based logic state.
Port is unauthorized, but unassigning
Guest VLAN failed.
Port was unauthorized, but 802.1X failed to remove the guest
VLAN of the port.
Secure handshake check:
Failures=fail-num, Flag=flag.
Handshake security check:
• Failures—Number of times that the handshake message fails to
pass the authentication. The user will be forced offline when the
value is larger than 2.
• Flag—Verification result, where 1 for success and 2 for failure.
Removed secure handshake hash of
handshake packet received from host.
802.1X removed the hash field from the handshake packet
received from the client.
Failed to delete the critical VLAN entry
(mac-address) on the interface
(IfIndex=ifindx).
802.1X failed to delete the MAC-based critical VLAN entry on the
interface.
Table 3 describes output fields and messages for the debugging dot1x event command.
8