HP Comware 5 Debug Manual Vol 1

<Sysname>debugging blacklist error
*Apr 10 20:47:54:734 2008 Sysname BLS/7/BLS Error:
Failed to create new blacklist.
// The device failed to add a new entry to the blacklist because the blacklist is full.
# Enable blacklist event debugging. Output similar to the following example is generated when the
device detects a scanning attack under the following conditions:
•
A scanning attack protection policy is configured on the device.
•
The blacklist function is enabled for scanning attack protection.
<Sysname> debugging blacklist event
*Apr 10 20:47:54:750 2008 Sysname BLS/7/BLS Event:
Drop packet for matching the blacklist.
IP address: 1.1.1.1
// The device dropped the packets whose source IP address is in the blacklist.
debugging flow-statistics
Use debugging flow-statistics to enable traffic statistics debugging.
Use undo debugging flow-statistics to disable traffic statistics debugging.
Syntax
debugging flow-statistics { all | error | event }
undo debugging flow-statistics { all | error | event }
Default
No traffic statistics debugging is enabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of traffic statistics debugging.
error: Specifies error debugging of traffic statistics.
event: Specifies event debugging of traffic statistics.
Usage guidelines
Table 56 describes output fields and messages for the debugging flow-statistics error command.
Table 56 Output from the debugging flow-statistics error command
Field
Description
IP statistic list is full.
Number of IP traffic statistics node entries has reached
the upper limit.
Failed to get time value.
The attack protection module failed to get the system
time.
116