HP Comware 5 Debug Manual Vol 1

rr: Specifies IPv4 recursive route debugging.
rtmsg: Specifies IPv4 routing table message debugging.
urt: Specifies IPv4 routing table debugging.
usr: Specifies IPv4 unicast static route debugging.
Usage guidelines
Ta b l e 61 describes output fields and messages for the debugging rm ipv4 im command.
Table 61 Output from the debugging rm ipv4 im command
Field
Description
IfnetIdx Interface index.
IfState Interface state.
Slot Slot number.
IfName Interface name.
IfType Interface type.
MsgType Message type.
InstID Interface instance ID.
Bandwidth Interface bandwidth.
Baudrate Baud rate.
MTU Maximum transmission unit (MTU).
Table 62 describes output fields and messages for the debugging rm ipv4 rcom command.
Table 62 Output from the debugging rm ipv4 rcom command
Field
Description
NH Next hop.
If Interface index.
Addr/Mask Interface address/mask.
Table 63 describes output fields and messages for the debugging rm ipv4 rr command.
Table 63 Output from the debugging rm ipv4 rr command
Field
Description
Add/Del Relay Radix ExtNode Add/delete the recursive next hop node.
Addr/Mask Next hop address/mask.
DstIns/NHIns Destination/next hop instance.
Table 64 describes output fields and messages for the debugging rm ipv4 rtmsg command.
Table 64 Output from the debugging rm ipv4 rtmsg command
Field
Description
received msg(XX,X) Type/Protocol ID of the received message.
122