HP Comware 5 Debug Manual Vol 1

Table 69 Output from the debugging rm job command
Field
Description
Job XXX
Job name:
• SelActRt—Optimal route selection job.
• NotifyRoute—Route notification job.
Examples
# Enable RM job debugging. When you configure an IPv4 static route, output similar to the following
example is generated:
<Sysname> debugging rm job
<Sysname> system-view
[Sysname] ip route-static 1.1.1.1 32 null 0
*Jan 9 16:15:17:969 2010 Sysname RM/3/RMDEBUG: Job SelActRt created (Pri:6,TID:3)
*Jan 9 16:15:17:969 2010 Sysname RM/3/RMDEBUG: Begin processing JOB SelActRt(6)
*Jan 9 16:15:17:969 2010 Sysname RM/3/RMDEBUG: Job NotifyRoute created (Pri:6,TID:5)
*Jan 9 16:15:17:969 2010 Sysname RM/3/RMDEBUG: Begin processing JOB NotifyRoute(6)
// RM created and executed the optimal route selection job and route notification job.
debugging rm policy
Use debugging rm policy to enable routing policy debugging.
Use undo debugging rm policy to disable routing policy debugging.
Syntax
debugging rm policy [ ip-prefix prefix-name ]
undo debugging rm policy
Default
Routing policy debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
ip-prefix prefix-name: Matches an IP prefix list.
Usage guidelines
Table 70 describes output fields and messages for the debugging rm policy command.
Table 70 Output from the debugging rm policy command
Field
Description
Prefix filter IPv4 prefix filter.
Prefix filter6 IPv6 prefix filter.
127