HP Comware 5 Debug Manual Vol 1

Field
Description
Receive shakehanding-pkt with proxy-chk tag
A port received a handshake packet with a
proxy-check tag.
Port control mode is portbase and there's users on port
portindex
The port control mode is port-based, and there are
users on port portindex.
Auth-Fail VLAN status is set to INITIAL because
unauthorization is successful.
The status of the Auth-Fail VLAN was set to INITIAL
because unauthorization was successful.
Deleted the MGV(mac-address) entry on same
interface (IfIndex=ifindex) after 802.1X authentication
failed.
After 802.1X authentication failed on an interface
(ifindex), the MGV entry (mac-address) was deleted
on the interface.
Deleted the critical VLAN entry (mac-address) before
adding it to the guest VLAN.
802.1X deleted the critical VLAN entry of the MAC
address before it adds the MAC address to the guest
VLAN.
Processing node CRITICAL... 802.1X is processing the nodes in CRITICAL state.
Table 4 describes output fields and messages for the debugging dot1x packet command.
Table 4 Output from the debugging dot1x packet command
Field Description
Code: Code EAP packet type.
Identifier: Identifier EAP packet identifier.
Length: Length EAP packet length.
Examples
# Enable 802.1X error debugging. Output similar to the following example is generated when a user
requests authentication under the following conditions:
•
802.1X is enabled on the device, and a RADIUS scheme is configured for user authentication.
•
VLAN 6 is configured as the 8 0 2.1 X guest VLAN on GigabitEthernet 1/1, and the port performs
MAC-based access control.
•
The multicast packet retransmission has timed out.
•
The network card of the client is disabled after the user passes authentication.
<Sysname> debugging dot1x error
*May 1 14:11:41:784 2000 Sysname 8021X/7/Error::Port:GigabitEthernet1/1, GuestVlan
assign failed, for port-mode is not portbased!
// 8 02.1 X failed to specify a guest VLAN for GigabitEthernet 1 / 1, because the port access control mode
is not
portbased .
*May 1 14:55:05:792 2000 Sysname 8021X/7/Error::Port:GigabitEthernet1/1,
Auth:211,Handshake time out ,make the user logoff...
// The handshake packet timed out and the user was logged off after the network card was disabled.
# Enable 802.1X event debugging. Output similar to the following example is generated when a user
requests authentication under the following conditions:
•
802.1X is enabled on the device.
•
A RADIUS scheme is configured for user authentication.
<Sysname> debugging dot1x event
11