HP Comware 5 Debug Manual Vol 1

undo debugging mpls lfib [ code | sync ]
Default
Debugging for MPLS entry synchronization and encoding/decoding is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
code: Specifies debugging for MPLS entry encoding and decoding.
sync: Specifies debugging for MPLS entry synchronization.
Usage guidelines
CAUTION:
Do not
enable debugging for MPLS entry encoding and decoding when a large number of entries are
to
be sent. Otherwise, the large amounts of command output might result in system abnormity.
The output debugging information for encoding is from the main MPU, and that for decoding is from the
interface card and the backup MPU.
This command is supported only on devices with single-core CPUs.
Table 76 describes output fields and messages for the debugging mpls lfib code command.
Table 76 Output from the debugging mpls lfib code command
Field
Description
SourceId Entry ID.
OperType Operation type.
Size Number of valid bytes in the entry.
CmdBlk Count Number of entries in the compressed packet.
CmdBlk Size Total number of entry bytes in the compressed packet.
Table 77 describes output fields and messages for the debugging mpls lfib sync command.
Table 77 Output from the debugging mpls lfib sync command
Field
Description
time cost Time cost, in milliseconds.
total size Total number of bytes.
CmdQ length Number of entries in the queue.
CmdQ size Total number of entry bytes in the queue.
Table 78 describes output fields and messages for the debugging mpls lfib command.
141