HP Comware 5 Debug Manual Vol 1

*Nov 29 17:01:54:549 2006 Sysname LSPC/7/Packet:
Send echo reply message on egress. Lenth: 100
00 01 00 00 02 02 03 01 00 00 00 01 00 00 00 01
00 1d 4c c6 00 00 02 a5 00 1e 39 fc 00 00 01 15
00 01 00 0c 00 01 00 05 30 30 30 30 20 00 00 00
00 03 00 30 02 41 42 43 44 45 46 47 48 49 4a 4b
4c 4d 4e 4f 50 51 52 53 54 55 56 57 58 59 5a 41
42 43 44 45 46 47 48 49 4a 4b 4c 4d 4e 4f 50 51
52 53 54 55
// LSP control received an echo reply message on the egress. The packet is 100bytes long.
*Nov 29 17:01:54:549 2006 Sysname LSPC/7/Event:
Receive echo request message on egress, reply successfully.
// LSP control received an echo request message on the egress and replied successfully.
debugging mpls management
Use debugging mpls management to enable debugging for the MPLS LSPM module.
Use undo debugging mpls management to disable MPLS LSPM debugging.
Syntax
debugging mpls management { all | event | interface | policy | process | tunnel }
undo debugging mpls management { all | event | interface | policy | process | tunnel }
Default
All types of MPLS LSPM debugging are disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of debugging for MPLS LSP management (LSPM).
event: Specifies debugging for MPLS LSPM events.
interface: Specifies debugging for MPLS LSPM interfaces sending and receiving messages.
policy: Specifies debugging for policies that LDP uses to create LSPs.
process: Specifies debugging for MPLS LSPM processing.
tunnel: Specifies debugging for MPLS LSPM tunnels.
Usage guidelines
When the LSPM module is not operating correctly, you can use the debugging mpls management
command to locate the problem. This command might decrease system performance. Use this command
only when required.
NOTE:
This command is supported only on devices with single-core CPUs.
149