HP Comware 5 Debug Manual Vol 1

Total CAPB Len : 8
Total OPT Len : 10
Total Message Len : 39
*Aug 24 15:32:02:630 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from ACTIVE to OPENSENT.
// After the connection is established, BGP sent an OPEN message to the peer.
*Aug 24 15:32:02:630 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Recv OPEN Length: 39
Version: 4, Local AS: 100, HoldTime : 180,
BGP ID: 10.1.1.2, TotOptLen: 10
OPT Type: 2 (Capability) OPT Len: 8
CAP Type: 1 (Multiprotocol) CAP Len: 4
IPv4-UNC (1/1)
CAP Type: 2 (RouteRefresh) CAP Len: 0
*Aug 24 15:32:02:630 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Current event is ReceiveOpenMessage.
// BGP received an OPEN message from the peer.
*Aug 24 15:32:02:646 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Send KEEPALIVE
Length 19
*Aug 24 15:32:02:646 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from OPENSENT to OPENCONFIRM.
%Aug 24 15:32:02:674 2006 Sysname RM/3/RMLOG:
BGP.: 10.1.1.2 State is changed from OPENCONFIRM to ESTABLISHED.
*Aug 24 15:32:02:674 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Recv KEEPALIVE
Length: 19
*Aug 24 15:32:02:674 2006 Sysname RM/6/RMDEBUG:
BGP. : 10.1.1.2 Current event is RecvKeepAliveMessage.
*Aug 24 15:32:02:674 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from OPENCONFIRM to ESTABLISHED.
// BGP has established the peer relationship successfully.
NOTE:
If two devices cannot establish a BGP peer relationship, you can compare the example debugging
information with the actual debugging information to locate the fault. For detailed descriptions of the
specific messages, see the following commands.
debugging bgp bfd
Use debugging bgp bfd to enable BGP BFD debugging.
Use undo debugging bgp bfd to disable BGP BFD debugging.
Syntax
debugging bgp bfd [ [ vpn-instance vpn-instance-name ] { ipv4-address | ipv6-address } ]
181