HP Comware 5 Debug Manual Vol 1

*Aug 24 14:12:13:674 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from ACTIVE to CONNECT.
*Aug 24 14:12:14:690 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from CONNECT to ACTIVE.
*Aug 24 14:12:13:706 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from ACTIVE to OPENSENT.
*Aug 24 14:12:13:706 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Current event is ReceiveOpenMessage.
// BGP received an Open message.
*Aug 24 14:12:13:706 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from OPENSENT to OPENCONFIRM.
// The state changed from OPENSENT to OPENCONFIRM.
%Aug 24 14:12:13:728 2006 Sysname RM/3/RMLOG:
BGP.: 10.1.1.2 State is changed from OPENCONFIRM to ESTABLISHED.
*Aug 24 14:12:13:728 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Current event is RecvKeepAliveMessage.
*Aug 24 14:12:13:728 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 State is changed from OPENCONFIRM to ESTABLISHED.
<Sysname>
*Aug 24 14:12:44:696 2006 Sysname RM/6/RMDEBUG:
BGP.: 10.1.1.2 Current event is RecvUpdateMessage.
// BGP had received an Update message.
debugging bgp graceful-restart
Use debugging bgp graceful-restart to enable GR event debugging for BGP.
Use undo debugging bgp graceful-restart to disable GR event debugging for BGP.
Syntax
debugging bgp [ ipv4-address | ipv6-address ] graceful-restart
undo debugging bgp [ ipv4-address | ipv6-address ] graceful-restart
Default
GR event debugging for BGP is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
ipv4-address: Specifies the IPv4 address of a peer.
ipv6-address: Specifies the IPv6 address of a peer.
Usage guidelines
After this debugging is enabled, the debugging information for the BGP GR operation will be displayed,
including the currently triggered event, state transitions, receiving/sending of EOR messages, and peer
186