HP Comware 5 Debug Manual Vol 1

RADIUS debugging commands
Some information in this chapter is device type specific. Devices in this chapter are categorized
depending on their IRF capability and support for interface cards that use independent processors for
forwarding traffic, as shown in Table 7.
Table 7 Device types
Device type
Interface cards with
on-card processors
IRF capability Examples
Distributed devices Yes
No
HP 6600 routers (except
for 6602)
Yes (in standalone mode)
HP 12500 switches
HP 10500 switches
Distributed IRF devices Yes Yes (in IRF mode)
HP 12500 switches
HP 10500 switches
Centralized devices No No
HP MSR routers
HP 6602 router
Centralized IRF devices No Yes
HP 5800 switches
HP 5500 switches
The output description tables in this document only contain fields and messages that require an
explanation.
debugging radius
Use debugging radius packet to enable RADIUS debugging.
Use undo debugging radius packet to disable RADIUS debugging.
Syntax
Centralized devices:
debugging radius packet [ acl acl-number | user username ]
undo debugging radius packet
Distributed devices/centralized IRF devices:
debugging radius packet [ acl acl-number | user username ] [ slot slot-number ]
undo debugging radius packet [ slot slot-number ]
Distributed IRF devices:
debugging radius packet [ acl acl-number | user username ] [ chassis chassis-number slot slot-number ]
undo debugging radius packet [ chassis chassis-number slot slot-number ]
Default
RADIUS debugging is disabled.
21