HP Comware 5 Debug Manual Vol 1

T a b l e 119 describes output fields and messages for the debugging voice ss ch fsm command.
Table 119 Output from the debugging voice ss ch fsm command
Field
Description
CH state move to XXX from XXX The CH state changed from xxx to xxx.
The service state of MCH changed from XXX to XXX. The MCH state changed from xxx to xxx.
Ta b l e 12 0 describes output fields and messages for the debugging voice ss ch info command.
Table 120 Output from the debugging voice ss ch info command
Field
Description
Successfully hold on local in XXX state. The call was successfully held at the local end.
Successfully unhold on local in XXX state. The call was successfully resumed at the local end.
Setup a new call when call hold. A new call was set up after the call was held.
Start a new CH service successfully. The CH service was successfully started.
CH service is finished at cause XXX. The CH service aborted for the reason of xxx.
Send the service message successfully in XXX state.
A SERVICE message was successfully sent in xxx
state.
Successfully send service acknowledge in XXX state.
A SERVICE ACK message was successfully sent in
xxx state.
Hookflash message is discarded in XXX state from
call-holdee.
A HOOKFLASH message from the held party was
discarded.
Deal with the saved hookflash in XXX state.
The cached HOOKFLASH message was processed
in xxx state.
Discard CMC_INFORMAITON message in XXX state. A CMC_INFORMATION message was discarded.
Received alerting message again in XXX state. A CMC_ALERTING message was received again.
Can not start CT service for ct-disable config in XXX
state.
The CT service could not be started because it was
not configured.
Start DTMF detect successfully, when enter a new call.
DTMF detection was successfully enabled for a new
call.
Close DTMF successfully, when dial the number.
DTMF detection was successfully disabled when the
dialed number was completely matched.
Close DTMF Detect successfully, when can not matching
the number dialed.
DTMF detection was successfully disabled when the
dialed number was not matched.
Close DTMF Detect successfully, when the new call is
overtime.
DTMF detection was successfully disabled when the
dialing timer for a new call expired.
Will enter BCT service in XXX state. The BCT service was to start.
To enter BCT service in XXX state. The BCT service was to start.
To enter ACT service in XXX state. The ACT service was to start.
To enter MCH service. The MCH service was to start.
Enter the new call service. A new call was set up.
Enter the hold service. The call was held.
232