HP Comware 5 Debug Manual Vol 1

Field
Description
Can not find the replaced leg in CTT
interface
The final recipient cannot find the leg to be replaced.
Cannot find XXX in SSS.
Similar debugging information includes:
Cannot get XXX in SSS.
Cannot process XXX in SSS.
This information indicates that something cannot be done. XXX
indicates the task that cannot be done. SSS indicates the position
where an error occurs.
Invalid connect state in CTT process for
CH
The connection state of the held call to be replaced was invalid.
The leg is already invalid after send
alerting in CTT process for idle
The leg might be exceptionally released after an ALERTING message
was sent.
Similar debugging information is in the following format:
The leg is already invalid after send MMM in SSS.
This information indicates that the leg was exceptionally released
after a message was sent. MMM indicates the type of the sent
message. SSS indicates the position where or the point of time when
an error occurs.
There is no MCH ccb in CTT process
for MCH
No MCH CCB was created when a held call was replaced in MCH.
Ta b l e 126 describes output fields and messages for the debugging voice ss ct event command.
Table 126 Output from the debugging voice ss ct event command
Field
Description
Receive CMC_RELEASE message from SA
module in CTO interface
The CTO interface received a CMC_RELEASE message from
the SA module.
Receive CMC_SERVICE message from SA
module in CTRinterface
The CTR interface received a CMC_SERVICE message from
the SA module.
Receive CMC_SETUP message from SA
module in CTT interface
The CTT interface received a CMC_SETUP message from the
SA module.
Receive CMC_RELEASE message from SA
module in originator's IDLE state
The CTO received a CMC_RELEASE message in the idle state.
Similar debugging information is in the following format:
Receive MMM message from FFF module in SSS state.
This information indicates that the xxx module received an xxx
message in xxx state. MMM indicates the received message.
FFF indicates the source module that sent the message to the
ST module. SSS indicates the state of the CT module when it
received the message.
247