HP Comware 5 Debug Manual Vol 1

HWTACACS debugging commands
Some information in this chapter is device type specific. Devices in this chapter are categorized
depending on their IRF capability and support for interface cards that use independent processors for
forwarding traffic, as shown in Table 9.
Table 9 Device types
Device type
Interface cards with
on-card processors
IRF capability Examples
Distributed devices Yes
No
HP 6600 routers (except
for 6602)
Yes (in standalone mode)
HP 12500 switches
HP 10500 switches
Distributed IRF devices Yes Yes (in IRF mode)
HP 12500 switches
HP 10500 switches
Centralized devices No No
HP MSR routers
HP 6602 router
Centralized IRF devices No Yes
HP 5800 switches
HP 5500 switches
The output description tables in this document only contain fields and messages that require an
explanation.
debugging hwtacacs
Use debugging hwtacacs to enable HWTACACS debugging.
Use undo debugging hwtacacs to disable HWTACACS debugging.
Syntax
Centralized devices:
debugging hwtacacs { all | error | event | message | receive-packet | send-packet }
undo debugging hwtacacs { all | error | event | message | receive-packet | send-packet }
Distributed devices/centralized IRF devices:
debugging hwtacacs { all | error | event | message | receive-packet | send-packet } [ slot slot-number ]
undo debugging hwtacacs { all | error | event | message | receive-packet | send-packet } [ slot
slot-number ]
Distributed IRF devices:
debugging hwtacacs { all | error | event | message | receive-packet | send-packet } [ chassis
chassis-number slot slot-number ]
undo debugging hwtacacs { all | error | event | message | receive-packet | send-packet } [ chassis
chassis-number slot slot-number ]
28