HP Comware 5 Debug Manual Vol 1

Tab l e 164 describes output fields and messages for the debugging cfd packet command.
Table 164 Output from the debugging cfd packet command
Field
Description
Send/Receive CFD Packet via port interface-type
interface-number
The device sent/received a CFD packet through a
port.
Pkt length Packet length.
Example
# Enable debugging for EAIS. When you enable port status-AIS collaboration, and configure the EAIS
frame transmission level and period, output similar to the following example is generated:
<Sysname> debugging cfd ais-track link-status packet
*0.99118462 Sysname EAIS/7/pkt:
Send EAIS Packet via Port Ethernet 1/1:
00 21 04 00 00
Pkt length: 5
// The device sent an EAIS packet out port Ethernet1/1
# Enable the debugging for sent and received CFD packets. The output in this example was created
when the following conditions exist:
•
Configure level-0 MDs, MAs, and service instances on the device.
•
Configure Ethernet 1/1 as an outbound MEP, setting the MEP ID to 100.
•
Configure the AIS frame transmission level as 5 for the service instance.
•
Enable the CFD service and CCM sending, and use the related commands to send LTM and LBM
packets to the MED configured on the remote end.
<Sysname> debugging cfd packet
*0.99737167 Sysname CFD/8/Pkt:
Send CFD Packet via port Ethernet1/1:
00 01 50 17 00 64 45 e6 02 07 6d 64 74 65 73 74
30 00 08 6d 61 74 65 73 74 31 30 01 00 00 02 00
01 01 00
Pkt length: 35
// The device sent a CFD packet out of Ethernet 1/1. The value 01 in the beginning of the packet
indicates that the packet is a CCM packet.
*0.99977386 Sysname CFD/8/Pkt:
Send CFD Packet via port Ethernet1/1:
00 05 00 04 00 64 95 28 08 00 0d 40 00 e0 fc 00
65 10 00 e0 fc 00 65 65 00
Pkt length: 25
// The device sent a CFD packet out of Ethernet 1/1. The value 05 in the beginning of the packet
indicates that the packet is a LTM packet.
*0.8434993 Sysname CFD/8/Pkt:
Send CFD Packet via port Ethernet1/1:
00 03 00 04 00 c8 d5 64 01 00 00 00
Pkt length: 12
304