HP Comware 5 Debug Manual Vol 1

Cluster management debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging ndp packet
Use debugging ndp packet to enable NDP packet debugging.
Use undo debugging ndp packet to disable NDP packet debugging.
Syntax
debugging ndp packet
undo debugging ndp packet
Default
NDP packet debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Ta b l e 165 describes output fields and messages for the debugging ndp packet command.
Table 165 Output from the debugging ndp packet command
Field
Description
Lenth NDP packet length.
TTL Aging time of an NDP packet on the receiving device.
Examples
# Enable debugging for NDP packets.
<Sysname> debugging ndp packet
*0.348945802 Sysname NDP/8/PKT:
Interface Ethernet1/1 Send Packet Lenth: 165 TTL: 180
*0.348946139 Sysname NDP/8/PKT:
Interface Ethernet1/2 Rcvd Packet Lenth: 138 TTL: 180
// The device sent an NDP packet out of Ethernet 1/1, and then it received an NDP packet from Ethernet
1/2.
debugging ntdp
Use debugging ntdp to enable NTDP debugging.
Use undo debugging ntdp to disable NTDP debugging.
308