HP Comware 5 Debug Manual Vol 1

Field
Description
TTL
Hop count of the NTDP topology collection request
packet.
Dest MAC Destination MAC address.
Snd Port Outgoing port.
Segment/Serial Fragment information.
Examples
# Enable NTDP packet debugging.
<Sysname> debugging ntdp message
*0.349815585 Sysname NTDP/8/Debug_Rcv_Msg:
Receiving Msg: Topology-Candidate Request
// A topology collection request message was received from the candidate device.
*0.349816750 Sysname NTDP/8/Debug_Snd_Msg:
Sending Msg:Candidate List
// A list message was sent to the cluster module.
debugging cluster
Use debugging cluster to enable cluster debugging.
Use undo debugging cluster to disable cluster debugging.
Syntax
debugging cluster { all | event | handshake | member | mrc | nat | packet | state }
undo debugging cluster { all | event | handshake | member | mrc | nat | packet | state }
Default
Cluster debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: All types of cluster debugging.
event: Debugging for cluster events.
handshake: Debugging for cluster handshake packets.
member: Debugging for cluster member list. This debugging is not in use, and its content is output in log.
mrc: Debugging for cluster Member Remote Control (MRC) packets.
nat: Debugging for cluster NAT rule configurations.
packet: Debugging for cluster management packets.
state: Debugging for cluster state changes.
310