HP Comware 5 Debug Manual Vol 1

# Enable NTDP packet data operation debugging.
<Sysname> debugging ntdp data
*Apr 27 04:48:33:891 2000 Sysname NTDP/7/Debug_NTDP_DATA_Operate:
NTDP data operation: Type--REFRESH, Device ID--0000-0000-00e0-fc00-3333
// An NTDP data operation was performed.
debugging cluster ext
Use debugging cluster ext to enable SNMP configuration synchronization debugging.
Use undo debugging cluster ext to disable SNMP configuration synchronization debugging.
Syntax
debugging cluster ext { event | packet }
undo debugging cluster ext { event | packet }
Default
SNMP configuration synchronization debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
event: Debugging for SNMP configuration synchronization events.
packet: Debugging for SNMP configuration synchronization packets.
Usage guidelines
Tab l e 177 describes output fields and messages for the debugging cluster ext event command.
Table 177 Output from the debugging cluster ext event command
Field
Description
Error: packet length is error The packet length is incorrect.
Tab l e 178 describes output fields and messages for the debugging cluster ext packet command.
Table 178 Output from the debugging cluster ext packet command
Field
Description
Sending/Receiving Extension Pkt An extended packet was sent or received.
MainCmd
Main command word, which indicates the packet type:
• 0—SNMP configuration synchronization request.
• 1—SNMP configuration synchronization response.
SrcMAC Source MAC address of the packet.
DstMAC Destination MAC address of the packet.
ParaLen Length of the sub-packet.
314