HP Comware 5 Debug Manual Vol 1

DCC debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging dialer
Use debugging dialer to enable a specific type of DCC (Dial Control Center) debugging.
Use undo debugging dialer to disable a specific type of DCC debugging.
Syntax
debugging dialer { all | event | packet }
undo debugging dialer { all | event | packet }
Default
All types of DCC debugging are disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: All types of DCC debugging.
event: Debugging for DCC events.
packet: Debugging for DCC packets.
Usage guidelines
Tab le 190 describes output fields and messages for the debugging dialer event command.
Table 190 Output from the debugging dialer event command
Field
Description
VLink index Virtual link index.
Link layer transfer user '' to DCC on interface
interface-type interface-number
Link layer transferred the peer name to DCC. If the peer
name is null, a null character is transferred.
peeraddr matching success on interface
interface-type interface-number ,link UP
Succeeded in matching the peer IP address, and the
link went up.
link-layer NCP negotiation is successful NCP negotiation succeeded.
received ISDN_CONN_CFM
DCC received ISDN connection confirmation
messages.
userId
ID of the confirmation. 0x9 indicates that the call has
been established.
father interface Parent interface.
345