HP Comware 5 Debug Manual Vol 1

DLSw debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
DLSw debugging commands
debugging dlsw
Use debugging dlsw to enable DLSw debugging.
Use undo debugging dlsw to disable DLSw debugging.
Syntax
debugging dlsw { circuit [ circuit-id ] | dlc { error | packet [ downstream | upstream ] } |
ethernet-backup | filter | reachable-cache | ssp { error | packet [ receive [ ip-address ] | send
[ ip-address ] ] } | tcp { error | remote [ ip-address ] } | udp }
undo debugging dlsw { circuit [ circuit-id ] | dlc { error | packet [ downstream | upstream ] } |
ethernet-backup | filter | reachable-cache | ssp { error | packet [ receive [ ip-address ] | send
[ ip-address ] ] } | tcp { error | remote [ ip-address ] } | udp }
Default
DLSw debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
circuit: Debugging for DLSw virtual circuit status.
circuit-id: Identifier of the DLSw virtual circuit, in the range of 0 to 0xFFFFFFFF.
dlc: Debugging for the DLC sub-module.
ethernet-backup: Debugging for Ethernet redundancy.
filter: Debugging for SAP address-based filtering.
reachable-cache: Debugging for reachability information.
ssp: Debugging for the SSP sub-module.
tcp: Debugging for the TCP sub-module.
udp: Debugging for the UDP sub-module.
error: Debugging for error information of all sub-modules.
packet: Debugging for packet contents of all sub-modules.
downstream: Specifies packets sent to the local SNA device.
388