HP Comware 5 Debug Manual Vol 1

Tab l e 210 describes output fields and messages for the debugging dlsw ethernet-backup command.
Table 210 Output from the debugging dlsw ethernet-backup command
Field
Description
DLSW_EB: Hold timeout
The IWANTIT timer expired. The UGOTIT or
CKT_TKN was sent.
DLSW_EB: Start hold timer interval = %d. Started the timer waiting for the IWANTIT frames.
DLSW_EB: There is no neighbor, master get the circuit.
There is no neighbor. The primary router established
the circuit.
DLSW_EB: Master get the circuit.
The primary router created the circuit through
calculation.
DLSW_EB: Master giveup the circuit.
The primary router gave up establishing the circuit.
The secondary router will establish the circuit.
DLSW_EB: Circuit exist on master, master get the
circuit.
The circuit already exists, and was created by the
primary router.
DLSw_EB : MASTER -> SLAVE State switchover.
DLSW_EB: Destination address map xxxx-xxxx-xxxx->
xxxx-xxxx-xxxx
Destination address mapping.
DLSW_EB: Source address map xxxx-xxxx-xxxx->
xxxx-xxxx-xxxx
Source address mapping.
T a b l e 2 11 describes output fields and messages for the debugging dlsw filter command.
Table 211 Output from the debugging dlsw filter command
Field
Description
lsap-output-acl xxxx Number of the ACL for packet filtering.
rule xxx Rule ID in the ACL.
The packet to x.x.x.x was discarded
The packet sent to the remote peer x.x.x.x was
discarded.
The head of the packet is below Packet header information.
Ta b l e 212 describes output fields and messages for the debugging dlsw ssp error command.
Table 212 Output from the debugging dlsw ssp error command
Field
Description
Error
An error that occurred in the SSP sub-module. This
error can be a module-level error, such as failure of
finding the DLSw virtual circuit for a packet, or a
system-level error, such as memory request failure.
Ta b l e 213 describes output fields and messages for the debugging dlsw ssp packet command.
Table 213 Output from the debugging dlsw ssp packet command
Field
Description
DLSw_PACKET ip-address IP address of the remote peer for the packet.
390