HP Comware 5 Debug Manual Vol 1

DDNS debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging ddns
Use debugging ddns to enable DDNS debugging.
Use undo debugging ddns to disable DDNS debugging.
Syntax
debugging ddns
undo debugging ddns
Default
DDNS debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 225 describes output fields and messages for the debugging ddns command.
Table 225 Output from the debugging ddns command
Field
Description
DDNS event (Interface: if-name, policy: policy-name)
A DDNS event occurs when interface if-name uses
DDNS policy policy-name for DDNS update.
Get server IP address ip-addr.
The system obtains the IP address ip-addr of the DDNS
server and is ready to initiate the DDNS update.
Authentication mode was sent.
The system has sent the authentication mode to the
PeanutHull server for the update.
Authentication request was sent.
The system has sent the authentication request to the
PeanutHull server for the update.
Domain name was sent.
The system has sent the domain name to the
PeanutHull server for the update.
DDNS server reply (Interface: if-name, policy:
policy-name):
packet-content
Reply (Interface: if-name, policy: policy-name) is
received from the DDNS server. The content of the
reply packet is packet-content.
DDNS error (Interface: if-name, policy: policy-name)
A DDNS error occurs on interface if-name using
DDNS policy policy-name for DDNS update.
Parameters incomplete. The DDNS policy lacks required parameters.
419