HP Comware 5 Debug Manual Vol 1

ManualsBrandsHP ManualsNetwork HardwareHP HSR68xx Configure-to-Order Router Solution

Usage guidelines

Table 20 describes output fields and messages for the debugging acfp client error command.

Table 20 Output from the debugging acfp server error command

Field

Description

Must bind EndTime with StartTime

The policy end time must be bound with the start time.

This information is output when the end time is not

configured.

Must bind StartTime with EndTime

The policy start time must be bound with the end time.

This information is output when the end time is not

configured.

Cannot specify both the inbound interface and the

outbound interface

The inbound interface and the outbound interface

cannot be specified at the same time.

Tab le 21 describes output fields and messages for the debugging acfp client error verbose command.

Table 21 Output from the debugging acfp server packet command

Filed

Description

IP mirrored packet was forwarded IP packet was mirrored to the destination port.

IP mirrored packet was fast forwarded

Mirrored IP packet was fast forwarded to the

destination port.

IP redirected packet was forwarded IP packet was redirected to the destination port.

IP redirected packet was fast forwarded

Redirected IP packet was fast forwarded to the

destination port.

IP mirrored or redirected packet was forwarded

Mirrored or redirected IP packet was forwarded to the

destination port.

Mirrored Packet was sent to slot slot-number

Mirrored packet was transparently transmitted to the

board in slot slot-number.

Redirected packet was sent to slot slot-number

Redirected packet was transparently transmitted to the

board in slot slot-number.

Examples

# Enable ACFP server error debugging. If you configure an ACFP client by using the MIB browser when

ACFP is disabled, output similar to the following example is generated:

<Sysname> debugging acfp server error

*Feb 24 10:33:58:500 2006 Sysname ACFP/7/debug:

ACFP_Error: ACFP is disabled.

// Configuration failed because ACFP was disabled.

# Enable ACFP server event debugging. If you configure an ACFP client by using the MIB browser when

ACFP is enabled, output similar to the following example is generated:

<Sysname> debugging acfp server event

*Feb 24 10:36:29:00 2006 Sysname ACFP/7/debug:

ACFP_Event: A client was added successfully.

// The ACFP client was created successfully.