HP Comware 5 Debug Manual Vol 1

Active and standby switchover debugging
commands
The output description tables in this document only contain fields and messages that require an
explanation.
The active and standby switchover module name is identified as "HA" in debugging messages.
debugging ha
Use debugging ha to enable active and standby switchover debugging.
Use undo debugging ha to disable active and standby switchover debugging.
Syntax
debugging ha { all | error | event | message | state }
undo debugging ha { all | error | event | message | state }
Default
Active and standby switchover debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of debugging for active and standby switchover.
error: Specifies debugging for active and standby switchover errors.
event: Specifies debugging for active and standby switchover events.
message: Specifies debugging for active and standby switchover messages.
state: Specifies debugging for active and standby switchover states.
Usage guidelines
Table 24 describes output fields and messages for the debugging ha error command.
69