HP Comware 5 Debug Manual Vol 1

Table 26 Output from the debugging ha message command
Field
Description
Sending Src MID = src-mid, Src SID = src-sid, Dst MID =
dst-mid, Dst SID = dst-sid, type = msg-type, Len = length,
Seq Num = msg-seq
HA sent a message to the destination module:
• src-mid—Source module ID.
• src-sid—Source module sub ID.
• dst-mid—Destination module ID.
• dst-sid—Destination module sub ID.
• msg-type—Message type.
• length—Message length.
• msg-seq—Message sequence number.
Deliver up Src MID = src-mid, Src SID = src-sid, Dst MID
= dst-mid, Dst SID = dst-sid, type = msg-type, Len =
length, Seq Num = msg-seq
HA sent a message to the application module.
From Module Src MID = src-mid, Src SID = src-sid, Dst
MID = dst-mid, Dst SID = dst-sid, type = msg-type, Len =
length, Seq Num = msg-seq
HA received a message from the application
module.
Table 27 describes output fields and messages for the debugging ha state command.
Table 27 Output from the debugging ha state command
Field
Description
IPC Channel is down IPC channel was down.
IPC Channel is UP IPC channel was up.
FSM State: Waiting For Slave To Insert.
The active MPU is waiting for the standby MPU to be
inserted into slot.
FSM State: Slave Have Been Inserted and Waiting for
batch backup request from slave.
The standby MPU is inserted into the slot, and the
active MPU is waiting for the standby MPU to send
batch backup requests.
FSM State: Batch backup.
The active and standby MPUs are performing batch
data backup.
FSM State: Realtime and routine backup. The active MPU is performing real-time data backup.
FSM State: Data smooth. The active MPU is performing data smoothing.
FSM State(slave): Ready. The standby MPU is ready.
FSM State(slave): Send batch backup request to AMB
The standby MPU is sending a batch backup request
to the active MPU.
FSM State(slave): Receiving batch data.
The standby MPU is receiving data in batches from
the active MPU.
FSM State(slave): Receiving realtime and routine data.
The standby MPU is receiving real-time data from the
active MPU.
Examples
# Enable active and standby switchover event debugging. When VLAN 3 is created on the device,
output similar to the following example is generated:
72