HP Comware 5 Debug Manual Vol 1

// Debugging information for adding an adjacency entry.
*Aug 19 14:28:39:875 2007 Sysname ADJ4/7/Adj4_Entry_Delete:
IP Address : 0.0.0.0 ulRouteIfIndex : S2/0
ulPhyfIndex : S2/0 ulLogicIfIndex : N/A
ucServiceType : PPP ucLinkMediaType : P2P
ucActionType : FORWARDING ulTimeStamp : 99013
usSlot : 0 ulVirtualCircuitInfo : N/A
ulMtu : 1500
LinkHeadLen(IP): 4 LinkHeadLen(MPLS) : 4
LinkHead(IP) : ff030021
LinkHead(MPLS) : ff030281
// Debugging information for deleting an adjacency entry.
debugging adjacent-table event
Use debugging adjacent-table event to enable IPv4 adjacency table event debugging.
Use undo debugging adjacent-table event to disable IPv4 adjacency table event debugging.
Syntax
debugging adjacent-table event
undo debugging adjacent-table event
Default
IPv4 adjacency table event debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 29 describes output fields and messages for the debugging adjacent-table event command.
Table 29 Output from the debugging adjacent-table event command
Field Description
ADJ4 ADD Entry Information Information about the added entry.
IP Address
Next hop address of the outgoing interface of the adjacency
table.
ulRouteIfIndex Routing interface.
ulPhyIfIndex Physical interface.
ulLogicIfIndex Logical interface.
ucServiceType
Service type of the adjacency entry, such as PPP and IP over
ATM. Only PPP is supported.
ucslot Slot number.
76