HP Comware 5 Debug Manual Vol 1

Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of 8 0 2.1 X debugging.
error: Specifies 802.1X error debugging.
event: Specifies 802.1X event debugging.
packet: Specifies 802.1X packet debugging.
slot slot-number: Specifies a card by its slot number. (Distributed devices—In standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. (Centralized IRF devices.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The chassis-number
argument represents the IRF member ID of the device. The slot-number argument represents the slot
number of the card. (Distributed devices—In IRF mode.)
Usage guidelines
Table 2 describes output fields and messages for the debugging dot1x error command.
Table 2 Output from the debugging dot1x error command
Field
Description
UCIB index: UCIBIndex User control information block index.
Wrong PortIfIndex. Illegal port logical index.
(SmartOn) Received an Error
msg(ErrCode)...
The SmartOn feature received an error message. ErrCode
represents the error code.
Check Reauth author info failed!!! 802.1X failed to examine re-authentication information.
specify VLAN ID to PVID failed. 802.1X failed to specify a VLAN ID as the PVID of the port.
DOT1X SuccessTrans Received an Error
Code ulParam2(ErrCode) of
MSG:GuestVlanUnAsgnResp...
In success state, 802.1X failed to clear the guest VLAN information
and received an error message.
ErrCode represents the error code.
DOT1X SuccessTrans Received an Error
Code ulParam2(ErrCode) of
MSG:VlanAsgnResp...
In success state, 802.1X failed to assign a VLAN to the user and
received an error message.
ErrCode represents the error code.
DOT1X SuccessTrans Received an Error
Code ulParam2(ErrCode) of
MSG:VlanUNAsgnResp...
In success state, 802.1X failed to remove users from the assigned
VLAN and received an error message.
ErrCode represents the error code.
DOT1X SuccessTrans Received an Error
msg(ErrCode)...
802.1X received a message that should not be received in success
state.
RealyState: when Relayed, receive a
relay msg again
802.1X received an 802.1X request again from the client.
DOT1X UnauthorTrans recv SC
AsgnVlan2Port Resp: ulParam2=ErrCode
802.1X failed to assign the VLAN. ErrCode represents the error
code.
7