R3303-HP HSR6800 Routers Interface Command Reference

125
display ft1
Use display ft1 to display the configuration and state information about a T1-F interface.
Syntax
display ft1 [ serial interface-number ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
serial interface-number: Specifies a serial interface by its number. If no interface is specified, this
command displays the information about all the T1-F interfaces.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If the specified interface is a common serial interface rather than a T1-F interface, the system will display
the prompt.
Examples
# Display information about T1-F interface Serial 2/0/0.
<Sysname> display ft1 serial 2/0/0
Serial2/0/0
Input: 0 packets, 0 bytes
0 broadcasts, 0 multicasts
0 errors, 0 runts, 0 giants
0 CRC, 0 align errors, 0 overruns
0 dribbles, 0 aborts
0 frame errors
Output:0 packets, 0 bytes
0 errors, 0 underruns, 0 collisions
0 deferred
Basic Configuration:
Work mode is T1 framed, Cable type is 100 Ohm balanced.
Frame-format is esf, fdl is none, Line code is b8zs.
Source clock is slave, Data-coding is normal.
Idle code is ff, Itf type is ff, Itf number is 2
Loop back is not set.
Alarm State:
Receiver alarm state is Loss-of-Signal.