R3303-HP HSR6800 Routers Interface Command Reference

129
Default command level
2: System level
Parameters
detect-timer: Period to check error packets, in the range of 30 to 600 seconds.
renew-timer: Period after which an interface resumes it function, in the range of 120 to 2,400 seconds.
threshold: Percentage of the ratio of error packets, in the range of 5 to 100.
Usage guidelines
The value of renew-timer must be at least four times of detect-timer. If the number of error packets received
during detect-timer is less than 100, they will be ignored by the system.
This command applies to CT1 interfaces, CE1 interfaces, E1-F interfaces, and T1-F interfaces only.
Examples
# Set the detect-timer to 100 seconds, renew-timer to 2400 seconds, and threshold to 15%.
<Sysname> system-view
[Sysname] error-diffusion restraint config 100 2400 15
error-diffusion restraint enable
Use error-diffusion restraint enable to enable error packets diffusion restraint.
Use undo error-diffusion restraint enable to disable this function.
Syntax
error-diffusion restraint enable
undo error-diffusion restraint enable
Default
Error packets diffusion restraint is enabled.
Views
System view
Default command level
2: System level
Usage guidelines
This command applies to CT1 interfaces, CE1 interfaces, E1-F interfaces, and T1-F interfaces only.
Examples
# Enable error packets diffusion restraint.
<Sysname> system-view
[Sysname] error-diffusion restraint enable
ft1 alarm
Use ft1 alarm to enable RAI detection on the interface.
Use undo ft1 alarm to disable RAI detection on the interface.