R3303-HP HSR6800 Routers Interface Command Reference

171
Usage guidelines
At the startup of the router, periodical alarm signal detection is enabled on all T1 lines on the CT3
interface. When a T1 line detects LOS, LOF, or AIS signals, it sends RAI signals to its peer. Alarm state
report for the interface is real time; you may view that with the display controller t3 command.
The supported alarm signals, LOS, LOF, AIS, RAI, FEBE, and idle, are ANSI T1.403 compliant.
You can configure a T1 line to send only a type of alarm signal. To have the channel send another type
of signal, use the undo t1 alarm command to remove the previous setting first. In addition, when the RAI
signal generated upon detection of the LOS, LOF, or AIS signal is present, the T1 line cannot send
another type of signal. To do that, use the undo t1 alarm detect command to disable the T1 line to send
the RAI signal generated after detecting an alarm first.
Examples
# Enable periodical alarm signal detection on T1 line 1 on CT3 interface T3 2/0/0.
<Sysname> system-view
[Sysname] controller t3 2/0/0
[Sysname-T3 2/0/0] t1 1 alarm detect
# Enable T1 line 1 on CT3 interface T3 2/0/0 to send AIS alarm signals.
<Sysname> system-view
[Sysname] controller t3 2/0/0
[Sysname-T3 2/0/0] t1 1 alarm generate ais
t1 bert
Use t1 bert to start a BERT test on the specified T1 line on the CT3 interface.
Use undo t1 bert to stop the BERT test running on the specified T1 line on the CT3 interface.
Syntax
t1 line-number bert pattern { 2^11 | 2^15 | 2^20 | 2^23 | qrss } time number [ unframed ]
undo t1 line-number bert
Default
No BERT test is performed.
Views
CT3 interface view
Default command level
2: System level
Parameters
line-number: T1 line number, in the range of 1 to 28.
pattern: Sets a BERT pattern, which could be 2^11, 2^15, 2^20, 2^23, or QRSS.
2^11: Specifies the length of transmitted BERT pattern, in bits, as two to the eleventh power.
2^15: Specifies the length of transmitted BERT pattern, in bits, as two to the fifteenth power.
2^20: Specifies the length of transmitted BERT pattern, in bits, as two to the twentieth power.
2^23: Specifies the length of transmitted BERT pattern, in bits, as two to the twenty third powers.