R3303-HP HSR6800 Routers Interface Command Reference

243
E-CPOS interace configuration commands
bandwidth
Use bandwidth to set the intended bandwidth for the E-CPOS interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
E-CPOS interface view
Default command level
2: System level
Parameters
bandwidth-value: Intended bandwidth for the E-CPOS interface, in the range of 1 to 4,294,967,295
kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used for bandwidth monitoring of the network management, but does not
affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 1000 kbps for interface E-CPOS 3/1/1.
<Sysname> system-view
[Sysname] controller e-cpos 3/1/1
[Sysname-E-Cpos3/1/1] bandwidth 1000
clock
Use clock to set the clock mode of the E-CPOS interface.
Use undo clock to restore the default.
Syntax
clock { master | slave }
undo clock
Default
The clock mode of an E-CPOS interface is slave.