R3303-HP HSR6800 Routers Interface Command Reference

248
Examples
# Set the framing format of interface E-CPOS 2/0/0 to SONET.
<Sysname> system-view
[Sysname] controller e-cpos 2/0/0
[Sysname-E-Cpos2/0/0] frame-format sonet
link-delay
Use link-delay to set the physical state change suppression interval on an E-CPOS interface. In case of an
up or down event, the E-CPOS interface comes up or goes down after the physical state change
suppression interval.
Use undo link-delay to restore the default.
Syntax
link-delay seconds
undo link-delay
Default
Physical state change suppression is disabled on an E-CPOS interface.
Views
E-CPOS interface view
Default command level
2: System level
Parameters
seconds: Sets the physical state change suppression interval on the E-CPOS interface, in the range of 0
to 10 seconds. The default is 0 seconds.
Usage guidelines
This command prevents frequent link state changes on an interface from affecting ongoing services.
Examples
# Set the physical state change suppression interval to 10 seconds on interface E-CPOS 2/0/0.
<Sysname> system-view
[Sysname] controller e-cpos 2/0/0
[Sysname-E-Cpos2/0/0] link-delay 10
loopback
Use loopback to set the loopback mode of the current E-CPOS interface.
Use undo loopback to disable loopback on the current E-CPOS interface.
Syntax
loopback { local | remote }
undo loopback