R3303-HP HSR6800 Routers Interface Command Reference

25
You can set an Ethernet interface to operate as Layer 2 Ethernet interfaces (in bridge mode) or Layer 3
Ethernet interfaces (in route mode).
After you change the link mode of an Ethernet interface, all settings are restored to their default values in
the new link mode.
Examples
# Configure GigabitEthernet 4/0/1 to operate in bridge mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] display this
#
interface GigabitEthernet4/0/1
port link-mode route
#
Return
The output shows that GigabitEthernet 4/0/1 operates in route mode.
[Sysname-GigabitEthernet4/0/1] port link-mode bridge
[Sysname-GigabitEthernet4/0/1] display this
#
interface GigabitEthernet4/0/1
port link-mode bridge
#
Return
The output shows that GigabitEthernet 4/0/1 is now operating in bridge mode.
NOTE:
The display this command displays the configuration that takes effect in the current view.
Related commands
port link-mode interface-list
port link-mode interface-list
Use port link-mode interface-list to change the link mode of Ethernet interfaces.
Syntax
port link-mode { bridge | route } interface-list
Views
System view
Default command level
2: System level
Parameters
bridge: Specifies the bridge (Layer 2) mode.
route: Specifies the route (Layer 3) mode.