R3303-HP HSR6800 Routers Interface Command Reference

29
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] shutdown
[Sysname-GigabitEthernet4/0/1] undo shutdown
# Shut down and then bring up GigabitEthernet 4/0/1.1.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1.1
[Sysname-GigabitEthernet4/0/1.1] shutdown
[Sysname-GigabitEthernet4/0/1.1] undo shutdown
# Shut down all member ports in the port group named group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 4/0/1
[Sysname-port-group-manual-group1] group-member gigabitethernet 4/0/1
[Sysname-port-group-manual-group1] shutdown
speed
Use speed to set the speed of an Ethernet interface.
Use undo speed to restore the default.
Syntax
speed { 10 | 100 | 1000 | auto }
undo speed
Views
Ethernet interface view
Default command level
2: System level
Parameters
10: Sets the interface speed to 10 Mbps.
100: Sets the interface speed to 100 Mbps.
1000: Sets the interface speed to 1000 Mbps.
auto: Enables the interface to negotiate a speed with its peer.
Usage guidelines
For an Ethernet copper port, use the speed command to set its speed to match the speed of the peer
interface.
For a fiber port, use the speed command to set its speed to match the rate of a pluggable transceiver.
Examples
# Configure GigabitEthernet 4/0/1 to operate at 100 Mbps.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] speed 100