R3303-HP HSR6800 Routers Interface Command Reference

81
Examples
# Set the virtual baudrate of DTE interface Serial 1/0/0 to 19200 bps.
<Sysname> system-view
[Sysname] interface serial 1/0/0
[Sysname-Serial1/0/0] virtualbaudrate 19200
Related commands
• baudrate
• clock
Basic CE1 interface configuration commands
Alarm
Use alarm to enable RAI detection on the interface.
Use undo alarm to disable RAI detection on the interface.
Syntax
alarm detect rai
undo alarm detect rai
Default
RAI detection is enabled on an interface.
Views
CE1 interface view
Default command level
2: System level
Parameters
detect: Enables periodical detection on the interface.
rai: Remote Alarm Indication (RAI).
Usage guidelines
This command is applicable when the interface operates in CE1 mode.
Examples
# Disable RAI detection on CE1 interface E1 2/0/0.
<Sysname> system-view
[Sysname] controller e1 2/0/0
[Sysname-E1 2/0/0] undo alarm detect ais
cable (CE1 interface)
Use cable to set the cable type for a CE1 interface.
Use undo cable to restore the default.