R3303-HP HSR6800 Routers IRF Configuration Guide

19
Ste
p
Command Remarks
3. Save the running
configuration.
save [ safely ] N/A
4. Reboot the member device.
reboot chassis chassis-number
The chassis-number must be the
same as the member-id specified
in the irf member member-id
renumber new-member-id
command.
Changing the priority of a member device
You can change the priority of a member device so it can be elected as the master at the next master
election.
A member priority change can affect the master re-election result, but does not cause immediate master
re-election.
To change the priority of a member device:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Specify a priority for a
member of an IRF fabric.
irf member member-id priority priority
The default IRF member priority
is 1.
Adding physical ports to an IRF port
An IRF port can have up to four physical ports. In IRF mode, you can add more physical ports to an IRF
port. This task does not affect the ongoing traffic on the IRF port.
When performing this task, follow the IRF physical port restrictions and configuration guidelines in "MPU
and I
RF physical port restrictions" and "Binding physical ports to IRF ports."
To
configure IRF ports:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A