R3303-HP HSR6800 Routers IRF Configuration Guide

Configuration procedure

IMPORTANT:

For two neighboring IRF members, IRF links must be bound to IRF-port 1 on one member and to IRF-por

2 on the other.

1. Configure Router A:

# Assign member ID 1 to Router A and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.

<Sysname> system-view

[Sysname] irf member 1

Info: Member ID change will take effect after the member reboots and operates in IRF

mode.

[Sysname] interface ten-gigabitethernet 3/0/1

[Sysname-Ten-GigabitEthernet3/0/1] shutdown

[Sysname-Ten-GigabitEthernet3/0/1] quit

[Sysname] irf-port 2

[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1

[Sysname-irf-port2] quit

[Sysname] interface ten-gigabitethernet 3/0/1

[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown

[Sysname-Ten-GigabitEthernet3/0/1] quit

# Save the configuration.

[Sysname] quit

<Sysname> save

# Enable IRF mode.

<Sysname> system-view

[Sysname] chassis convert mode irf

The device will switch to IRF mode and reboot. You are recommended to save the current

running configuration and specify the configuration file for the next startup.

Continue? [Y/N]:y

Do you want to convert the content of the next startup configuration file

flash:/startup.cfg to make it available in IRF mode? [Y/N]:y

Please wait...

Saving the converted configuration file to the main board succeeded.

Slot 1:

Saving the converted configuration file succeeded.

Now rebooting, please wait...

Router A reboots to form a one-chassis IRF fabric.

2. Configure Router B:

# Assign member ID 2 to Router B and bind Ten-GigabitEthernet 3/0/1 to IRF-port 1.

<Sysname> system-view

[Sysname] irf member 2

Info: Member ID change will take effect after the member reboots and operates in IRF

mode.

[Sysname] interface ten-gigabitethernet 3/0/1

[Sysname-Ten-GigabitEthernet3/0/1] shutdown

[Sysname-Ten-GigabitEthernet3/0/1] quit

[Sysname] irf-port 1