R3303-HP HSR6800 Routers IRF Configuration Guide

[Sysname-irf-port1] quit

[Sysname] interface ten-gigabitethernet 3/0/1

[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown

[Sysname-Ten-GigabitEthernet3/0/1] quit

# Save the configuration.

[Sysname] quit

<Sysname> save

# Connect the two devices as shown in Figure 15.

# Log in to Router B. (Details not shown.)

# Enable IRF mode.

<Sysname> system-view

[Sysname] chassis convert mode irf

The device will switch to IRF mode and reboot. You are recommended to save the current

running configuration and specify the configuration file for the next startup.

Continue? [Y/N]:y

Do you want to convert the content of the next startup configuration file

flash:/startup.cfg to make it available in IRF mode? [Y/N]:y

Please wait...

Saving the converted configuration file to the main board succeeded.

Slot 1:

Saving the converted configuration file succeeded.

Now rebooting, please wait...

Router B reboots to join the IRF fabric. A two-chassis IRF fabric is formed.

3. Configure BFD MAD:

# Create VLAN 3, and add GigabitEthernet 1/4/0/1 and GigabitEthernet 2/4/0/1 to VLAN 3.

<Sysname> system-view

[Sysname] vlan 3

[Sysname-vlan3] port gigabitethernet 1/4/0/1 gigabitethernet 2/4/0/1

[Sysname-vlan3] quit

# Create VLAN-interface 3 and configure a MAD IP address for each member device on the VLAN

interface.

[Sysname] interface vlan-interface 3

[Sysname-Vlan-interface3] mad bfd enable

[Sysname-Vlan-interface3] mad ip address 192.168.2.1 24 member 1

[Sysname-Vlan-interface3] mad ip address 192.168.2.2 24 member 2

[Sysname-Vlan-interface3] quit

# Disable the spanning tree feature on GigabitEthernet 1/4/0/1 and GigabitEthernet 2/4/0/1.

[Sysname] interface gigabitethernet 1/4/0/1

[Sysname-gigabitethernet-1/4/0/1] undo stp enable

[Sysname-gigabitethernet-1/4/0/1] quit

[Sysname] interface gigabitethernet 2/4/0/1

[Sysname-gigabitethernet-2/4/0/1] undo stp enable