R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

111
Configuring frame relay
Overview
Frame relay is essentially simplified X.25 WAN technology. It uses statistical multiplexing technology and
can establish multiple virtual circuits over a single physical cable to make full use of network bandwidth.
Frame relay uses data link connection identifiers (DLCIs) to identify virtual circuits and maintain the status
of each virtual circuit with the Local Management Interface (LMI) protocol.
Frame relay interface types
As shown in Figure 34, frame relay enables communication between user devices such as routers and
hosts. The user devices are also called "data terminal equipment (DTE)." They are connected to a frame
relay network through the DTE interface. The devices that provide access to the frame relay network for
DTEs are called "data communications equipment (DCE)." A DCE is connected to a DTE with a DCE
interface on the user network interface (UNI) side and to a frame relay switch in the frame relay network
with a network-to-network interface (NNI) on the NNI side. The switches in the frame relay cloud are
interconnected with the NNI.
In actual applications, a DTE interface can connect to only a DCE interface, and an NNI interface can
connect to only an NNI interface. On a frame relay switch, the frame relay interface should be an NNI
or DCE interface.
As shown in Figure 34, R
outer B and Router C form a simple frame relay network, to which DTE devices
Router A and Router D are attached. The DTE and DCE are identified on only the UNI interface; a virtual
circuit between two DTE devices can be assigned different DLCIs on different segments.
Figure 34 Example frame relay network