R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

6
OAM CC works on a PVC, where one side of the PVC sends OAM cells to its peer. The peer checks the
connection status based on these OAM cells.
ATM configuration task list
Task Remarks
Configuring an ATM interface Required.
Configuring
an ATM
subinterface
Performing basic configurations for an ATM subinterface
Optional.
Checking PVC status to determine the protocol state of an ATM P2P subinterface
Configuring
PVCs and
the
maximum
number of
PVCs
allowed on
an interface
Configuring PVC parameters Required.
Setting the CLP bit for ATM cells
Optional.
Assigning a transmission priority to an ATM PVC
Configuring PVC service mapping Optional.
Configuring the maximum number of PVCs allowed on an ATM interface Optional.
Configuring an ATM class Optional.
Configuring VP policing Optional.
Configuring
applications
carried by
ATM
Configuring VE interfaces Required.
Configuring IPoA
Required.
Use one of
the
approaches.
Configuring IPoEoA
Configuring PPPoA
Configuring PPPoEoA
Configuring an ATM interface
Depending on the actual networking environment and system requirements, you might need to modify
certain parameters of an ATM interface.
Except the mtu command, which can be configured on a subinterface, the ATM settings in this section
must be modified in ATM main interface view, although they apply to both the main ATM interface and
its subinterfaces.
For more information about ATM interface configuration, see Interface Configuration Guide.
Configuring an ATM subinterface
Performing basic configurations for an ATM subinterface