R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

118
Configuring DCE side frame relay
Configuring basic DCE side frame relay
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable frame relay on the
interface.
link-protocol fr [ ietf |
nonstandard ]
The default link layer protocol on a
WAN interface is PPP. If frame
relay is enabled with no operating
mode specified, the IETF standard
applies.
4. Configure the frame relay
interface type as DCE or NNI.
fr interface-type { dce | nni } The default setting is DTE.
5. Configure the frame relay LMI
protocol type.
fr lmi type { ansi | nonstandard |
q933a }
Optional.
The default setting is q933a.
6. Configure network side
N392.
fr lmi n392dce n392-value
Optional.
The default setting is 3.
7. Configure network side
N393.
fr lmi n393dce n393-value
Optional.
The default setting is 4.
8. Configure network side T392.
fr lmi t392dce t392-value
Optional.
The default setting is 15 seconds.
Configuring frame relay address mapping on the DCE side
See "Configuring frame relay address mappings."
Configuring frame relay local virtual circuit on the DCE side
See "Configuring a frame relay local virtual circuit."
Configuring frame relay subinterface on the DCE side
See "Configuring a frame relay subinterface."
Configuring frame relay switching
A device with frame relay switching enabled can operate as a frame relay switch.
To configure frame relay switching, configure static routes in interface view, or configure PVCs in system
view.