R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

119
The interfaces used for frame relay switching must be NNI or DCE.
To configure frame relay switching:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable frame relay switching.
fr switching N/A
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Set the type of an interface for
frame relay switching to NNI or
DCE.
fr interface-type { dce | nni }
The default frame relay
interface type is DTE, which
does not support frame relay
switching.
5. Return to system view.
quit N/A
6. Configure a PVC for frame relay
switching in system view.
a. fr switch name interface
interface-type
interface-number dlci dlci1
interface interface-type
interface-number dlci dlci2
A PVC created in this method
is bidirectional.
b. fr switch name
Optional.
Enter frame relay switching
PVC view.
c. undo shutdown
Optional.
Enable the current switching
PVC.
Enabling the trap function
The trap function enables the frame relay module to report critical events to the information center. You
can configure the information center to output interesting trap messages to a destination (for example, the
console) for analysis. For more information about how to configure the information center, see Network
Management and Monitoring Configuration Guide.
To enable the trap function for the frame relay module:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable trap for frame
relay.
snmp-agent trap enable fr
Optional.
By default, trap is enabled
for frame relay.
For more information about the snmp-agent trap enable fr command, see Network Management and
Monitoring Command Reference.
Displaying and maintaining frame relay