R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

128
Figure 40 Network diagram
Configuration procedure
1. Configure Router A:
# Create and configure MFR interface 4/0/0 (MFR4/0/0).
<RouterA> system-view
[RouterA] interface mfr 4/0/0
[RouterA-MFR4/0/0] ip address 10.140.10.1 255.255.255.0
[RouterA-MFR4/0/0] fr interface-type dte
[RouterA-MFR4/0/0] fr map ip 10.140.10.2 100
[RouterA-MFR4/0/0] quit
# Bundle Serial 2/0/1 and Serial 2/0/2 to MFR4/0/0.
[RouterA] interface serial 2/0/1
[RouterA-Serial2/0/1] link-protocol fr mfr 4/0/0
[RouterA-Serial2/0/1] quit
[RouterA] interface serial 2/0/2
[RouterA-Serial2/0/2] link-protocol fr mfr 4/0/0
2. Configure Router B:
# Create and configure MFR interface 4/0/0 (MFR4/0/0).
<RouterB> system-view
[RouterB] interface mfr 4/0/0
[RouterB-MFR4/0/0] ip address 10.140.10.2 255.255.255.0
[RouterB-MFR4/0/0] fr interface-type dce
[RouterB-MFR4/0/0] fr dlci 100
[RouterB-fr-dlci-MFR4/0/0-100] quit
[RouterB-MFR4/0/0] fr map ip 10.140.10.1 100
[RouterB-MFR4/0/0] quit
# Bundle Serial 2/0/1 and Serial 2/0/2 to MFR4/0/0.
[RouterB] interface serial 2/0/1
[RouterB-Serial2/0/1] link-protocol fr mfr 4/0/0
[RouterB-Serial2/0/1] quit
[RouterB] interface serial 2/0/2
[RouterB-Serial2/0/2] link-protocol fr mfr 4/0/0
MFR switched connection configuration example
Network requirements
As shown in 错误！未找到引用源。, Router A and Router C are connected through MFR to Router B where
MFR switching is enabled.