R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

10
Step Command Remarks
10. Return to system view.
quit N/A
11. Enter ATM interface or
subinterface view.
interface atm { interface-number |
interface-number.subnumber }
N/A
12. Create a PVC and enter PVC
view.
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
By default, no PVC is created.
13. Apply the QoS policy on the
PVC.
qos apply policy policy-name
{ inbound | outbound }
N/A
For more information about classes, traffic behaviors, and policies, see ACL and QoS Configuration
Guide.
Assigning a transmission priority to an ATM PVC
You can assign transmission priorities to ATM PVCs associated with the UBR, rt-VBR, or nrt-VBR service.
At the time of bandwidth allocation, the PVC with higher priority has priority over other PVCs.
To assign a transmission priority to an ATM PVC:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter ATM interface or
subinterface view.
interface atm { interface-number |
interface-number.subnumber }
N/A
3. Create a PVC and enter PVC
view.
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
N/A
4. Assign a transmission priority
to the ATM PVC.
transmit-priority value
Optional.
By default, the priority value is 0
for the UBR service, 5 for the
nrt-VBR service and 8 for the rt-VBR.
Only MIM-ATM interface modules
support configuring transmission
priorities.
Configuring PVC service mapping
PVC service mapping allows different PVCs from the same PVC-Group to carry IP packets of different
priorities.
A primary PVC refers to the one based on which a PVC-group is created on an ATM interface. A
secondary PVC refers to a PVC created in a PVC-group.
To configure PVC service mapping:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A