R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

# Enter the view of the ATM 1/0/1 interface and configure an IP address for it.

<RouterC> system-view

[RouterC] interface atm 1/0/1

[RouterC-Atm1/0/1] ip address 202.38.160.3 255.255.255.0

# Establish a PVC and enable it to carry IP.

[RouterC-Atm1/0/1] pvc to_a 0/60

[RouterC-atm-pvc-Atm1/0/1-0/60-to_a] map ip 202.38.160.1

[RouterC-atm-pvc-Atm1/0/1-0/60-to_a] quit

[RouterC-Atm1/0/1] pvc to_b 0/61

[RouterC-atm-pvc-Atm1/0/1-0/61-to_b] map ip 202.38.160.2

IPoEoA configuration example

Network requirements

As shown in Figure 6, each of the hosts in the two Ethernets is respectively connected to the ATM network

through an ADSL Router, and they communicate with Router C through DSLAM.

The IP address of the VE interface of Router C is 202.38.160.1.

The VPI/VCI value of two PVCs connecting Router C and DSLAM are 0/60 and 0/61, pointing to Router

A and Router B respectively.

Both the WAN port of Router C and the DSL interfaces of the ADSL Routers adopt IPoEoA.

Figure 6 Network diagram

Configuration procedure

Configure Router C:

# Create a VE interface and configure an IP address for it.

<RouterC> system-view

[RouterC] interface virtual-ethernet 1/0/1

[RouterC-Virtual-Ethernet1/0/1] ip address 202.38.160.1 255.255.255.0

[RouterC-Virtual-Ethernet1/0/1] quit

# Create a PVC and enable IPoEoA on it.

[RouterC] interface atm 1/0/1.1

Ethernet