R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

• On Router B, two channels are created with the interface names Serial 2/0/1:1 and Serial 2/0/1:2.

It is the same case with Router C.

Do the following:

• Bind two channels on Router A with the two channels on Router B and another two channels with

the two channels on Router C.

• Adopt binding authentication.

Figure 16 Network diagram

Configuration procedure

1. Configure Router A:

# Create user accounts for Router B and Router C and set the passwords.

<RouterA> system-view

[RouterA] local-user router-b

[RouterA-luser-router-b] password simple router-b

[RouterA-luser-router-b] service-type ppp

[RouterA-luser-router-b] quit

[RouterA] local-user router-c

[RouterA-luser-router-c] password simple router-c

[RouterA-luser-router-c] service-type ppp

[RouterA-luser-router-c] quit

# Create two VT interfaces for the two user accounts.

[RouterA] ppp mp user router-b bind virtual-template 1

[RouterA] ppp mp user router-c bind virtual-template 2

# Configure the VT interfaces.

[RouterA] interface virtual-template 1

[RouterA-Virtual-Template1] ip address 202.38.166.1 255.255.255.0

[RouterA-Virtual-Template1] quit

[RouterA] interface virtual-template 2

[RouterA-Virtual-Template2] ip address 202.38.168.1 255.255.255.0

[RouterA-Virtual-Template2] quit

# Add interfaces Serial 2/0/1:1, Serial 2/0/1:2, Serial 2/0/1:3, and Serial 2/0/1:4 to MP

channels. Take Serial 2/0/1:1 as an example.

[RouterA] interface serial 2/0/1:1

[RouterA-Serial2/0/1:1] link-protocol ppp

[RouterA-Serial2/0/1:1] ppp mp