R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

0 lost fragments, 0 reordered, 0 unassigned, 0 interleaved,

sequence 0/0 rcvd/sent

The bundled member channels are:

Serial2/0/2

Serial2/0/1

4. Display the status of the VA interfaces:

[RouterA] display virtual-access

Virtual-Template1:0 current state: UP

Line protocol current state: UP

Description: Virtual-Template0:0 Interface

The Maximum Transmit Unit is 1500

Link layer protocol is PPP

LCP opened, MP opened, IPCP opened, OSICP opened

Physical is MP, baudrate: 64000 bps

Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0

Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0

Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0

Last 300 seconds input: 0 bytes/sec 0 packets/sec

Last 300 seconds output: 0 bytes/sec 0 packets/sec

520 packets input, 44132 bytes, 0 drops

527 packets output, 44566 bytes, 4 drops

The output on Router B is similar.

5. Ping the IP address 8.1.1.1 on Router B:

[RouterB] ping 8.1.1.1

PING 8.1.1.1: 56 data bytes, press CTRL_C to break

Reply from 8.1.1.1: bytes=56 Sequence=1 ttl=255 time=29 ms

Reply from 8.1.1.1: bytes=56 Sequence=2 ttl=255 time=31 ms

Reply from 8.1.1.1: bytes=56 Sequence=3 ttl=255 time=29 ms

Reply from 8.1.1.1: bytes=56 Sequence=4 ttl=255 time=31 ms

Reply from 8.1.1.1: bytes=56 Sequence=5 ttl=255 time=30 ms

--- 8.1.1.1 ping statistics ---

5 packet(s) transmitted

5 packet(s) received

0.00% packet loss

round-trip min/avg/max = 29/30/31 ms

Because PPP authentication is configured on the physical interface, the bundle field in the output

from the display ppp mp command is the peer username. If authentication is disabled, the bundle

field should be the peer descriptor.

In addition, you can check the state of MP virtual channels by checking the state of virtual access

interfaces by using the display virtual-access command.

(Method 2) Associate the remote username with a VT interface.

6. Configure Router A:

# Configure the username and password of Router B.

<RouterA> system-view

[RouterA] local-user rtb

[RouterA-luser-rtb] password simple rtb