R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

69
Figure 19 Network structure 2
Protocols and standards
RFC 2516, A Method for Transmitting PPP Over Ethernet (PPPoE)
Configuring a PPPoE server
You can configure PPPoE servers on Ethernet ports or virtual Ethernet interfaces created on ADSL
interfaces. For more information about configuring PPPoE servers on virtual Ethernet interfaces, see
"Configuring ATM."
Cross-card Layer 3 aggregate interfaces do not support this feature.
To configure a PPPoE server:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VT interface.
interface virtual-template number
This operation also leads you to
virtual template view.
3. Set PPP parameters (including
authentication type, IP
address negotiation, and so
on); optionally, specify the IP
address to be allocated to the
peer or define an IP address
pool.
See "Configuring PPP
authentication."
Optional.
4. Enter Ethernet interface view.
interface interface-type
interface-number
N/A
5. Enable PPPoE on the Ethernet
interface and bind this
interface to a specified VT
interface.
pppoe-server bind virtual-template
number
Disabled by default.
6. Return to system view.
quit N/A
7. Set the maximum number of
PPPoE sessions allowed for a
peer MAC address.
pppoe-server max-sessions
remote-mac number
Optional.
100 by default.
Internet
PPPoE server
Host A
Host B
Router
PPPoE client
PPPoE client